When illicit drug emissions settle and reconstitute in clandestine labs, they can form stubborn bonds with the walls, ceilings, and surfaces – making safe and effective removal tough.
Actichem’s meth decontamination cleaning products break down and lift these residues for thorough remediation. Whether you’re treating affected homes, vehicles, or commercial sites, the high-performance MethSan system gets the job done effectively without costly re-dos.
Powerful prewash for meth & illicit drug lab clean-ups
The success of a high reading Drug Lab Remediation process depends on a prewash based on innovative, purpose built chemistry (not just sugar soap) and a thorough application procedure.
Potentiated Hydrogen Peroxide Decontaminant
The main wash must ensure that all the chemical substance residues are either physically removed or deactivated.
Advanced additive for fogging application of MethSan
MethSan Fog Boost is specifically designed to supercharge the chemical and biological removal properties of MethSan. Formulated to enable MethSan to be applied by ULV fogging, superwetting and carbon-chasing agents enable high-performance decontamination.
Advanced additive for foaming application of MethSan
MethSan Foam Boost is specifically designed to supercharge the chemical and biological removal properties of MethSan. Â Formulated to enable MethSan to be applied by foam-generating equipment, superwetting and carbon-chasing agents enable high-performance decontamination.
Process
-
Dilute MethSan PreWash and apply to surface
Dilute the MethSan Prewash 1:4 with water. Apply MethSan Prewash to the surface and agitate well using a red pad and/or a brush
-
Rinse MethSan PreWash
Rinse well: For smooth surfaces use a wet sponge, for rough surfaces use a sprayer.
Ensure surfaces are not shiny wet before proceeding -
Prepare main wash solution and apply to surface
Mix 4lt of MethSan Part A with 1lt of MethSan Part B (Part B can be either the Fog Boost or the Foam Boost).
Apply the solution to the surfaces using the correct equipment.
-
Agitate surface and dwell for sufficient time depending on readings
Agitate thoroughly: for smooth surfaces use a Red Pad. For rough surfaces use a brush. Re-agitate every 30 minutes.
Low readings allow 45 minutes dwell time. Medium readings allow 1 hour dwell time. High readings allow 2 hours dwell time.
Keep the surface wet by reapplying the solution if required.
-
Rinse solution from surface
Rinse well: For smooth surfaces use a wet sponge, for rough surfaces use a sprayer.
Additional Notes
-
Boosting MainWash
For Ultra Performance, use 50% strength Hydrogen Peroxide (Actichem Perox) in place of the MethSan Part A (note that additional WHS is required; solution may damage surfaces)
-
PPE Required
Gloves, Goggles, and/or face shield, appropriate breathing apparatus.
Where to buy
MethSan (A)
Potentiated Hydrogen Peroxide Decontaminant
Potentiated Hydrogen Peroxide Decontaminant
Find a Stockist
